Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Login


Take the time to read our Privacy Policy.

Guest
#1 Posted : Thursday, 1 April 2004 9:43:15 PM(UTC)
Guest

Rank: Guest

Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977

Was thanked: 4 time(s) in 4 post(s)
Hi all,
Hoping someone can help - how hard is it to replace valve stem oil seals - this is on a 250 2V (precrossflow) - I've read that you can do this without removing head by either pressurising cylinder with air or by stuffing nylon rope thru plug hole (that was in a Ford manual) Anyone done this? How hard? How much do the set of seals cost?


Thanks!!!

Guest
#2 Posted : Friday, 4 June 2004 2:45:04 PM(UTC)
Guest

Rank: Guest

Groups: Guests
Joined: 2/09/2015(UTC)
Posts: 43,977

Was thanked: 4 time(s) in 4 post(s)
pressurise the cyl is ok if the valves seal properly.
seals are worth peanuts ( only umbrella type ) be sure to loosen the collets while still in retainer with a sharp whack with soft hammer before u compress the spring and remove.
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF | YAF © 2003-2022, Yet Another Forum.NET
This page was generated in 0.041 seconds.