Rank: Member
Groups: Registered
Joined: 6/16/2008(UTC)
Posts: 21
|
Hey guys,
So, having a few problems! Just before I let go of the clutch the car rumbles a little or jolts. Once I let go it is fine. The car is a VP. I had the clutch and cluth bearing replaced at 230,000kms a little over a year ago. Im now at 280,000kms. A mate said it might just be the cable. What is wrong with my car? Or is it something totally different?
Any help would be greatly appreciated!
Thanks
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/12/2010(UTC)
Posts: 70
|
did you get the flywheel machined while you had the clutch out?
|
|
|
|
|
|
Rank: Veteran
Groups: Veteran, Registered
Joined: 11/25/2008(UTC)
Posts: 1,496
|
sounds like the thrust bearing is giving up, if it is the thrust bearing and gets worse the engine will stall when you push the clutch in
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 6/16/2008(UTC)
Posts: 21
|
Not sure if the flywheel was machined. Report from when clutch was replaced-
attended to rattle in clutch area, found clutch worn and clutch dampers worn-replaced. also replaced speedo transducer as broken.
If it helps when the clutch is released it squeeks the tiniest bit.
Cheers to those who have answered
|
|
|
|
|
|
Rank: Veteran
Groups: Registered
Joined: 1/25/2010(UTC)
Posts: 1,116
Thanks: 1 times
Was thanked: 17 time(s) in 16 post(s)
|
My parents had a VR manual and the clutch cable was always half seized up. Is it hard to push the pedal down? Try a new cable before you doing anything else.
If the flywheel wasnt machined and the clutch has been given a hard time then it will shudder when you let the clutch out.
|
|
|
|
|
|
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
