Fastlane
»
Holden Forums
»
Holden Technical Talk
»
reverse sensor position on a VY ute
Rank: Member
Groups: Registered
Joined: 8/12/2005(UTC)
Posts: 183
|
I've got a set of aftermarket reverse sensors for my VY Ute. The problem is I'm not sure where to put them. The instructions say to put the outer ones 12 to 15 cm from the edge but I've only got 10.(it's the 2 rear bumpers) Can I put them closer to the edge and will it make a difference in the sensitivity. As well where do I place the inner 2 without being effected by the tow bar? Were they available as an extra on this model and if so, what was the positioning? Any help is appreciated. cheers...bluHJ Edited by user Saturday, January 22, 2011 6:34:51 PM(UTC)
| Reason: Not specified
|
|
|
|
|
|
Rank: Veteran
Groups: Registered, Veteran
Joined: 3/1/2005(UTC)
Posts: 2,047
|
I don`t think utes came out with factory fitted sensors, if you back into your garage for parking i would put them in the middle of the bumpers or toward the outer edge.
|
|
|
|
|
|
Rank: Member
Groups: Registered
Joined: 8/12/2005(UTC)
Posts: 183
|
Thanks Cloudy. I wasn't sure if they were an option. I'm just concerned that if I put them too close to the edge of the bumper, they may be TOO sensitive.
I'll have to think about it. May even put them on the wife's VX sedan instead.
cheers...bluHJ
|
|
|
|
|
|
Fastlane
»
Holden Forums
»
Holden Technical Talk
»
reverse sensor position on a VY ute
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
